Notes:

Engine Location:
Prototype vehicle engine was mounted on front and mid engine plates.

Left to right:
The centerline of the crank to the idlerarm mounting surface on frame rail is 10-3/4".

2. Vertical (Up-down):
Centerline of crank to a level line from the center line of upper idlerarm bolt is 9/16"

3. Front to rear:
Front of block to centerline of upper idlerarm bolt is 3-7/16"

Steering shaft:
1. Steering shaft must have an additional u-joint installed  (Can use steering u-joint as manufactured by Borgeson Universal Co. www.borgeson.com)

Heater/AC:
1. no heater/AC on prototype vehicle

Brakes:
1.  Power brake booster will not fit

Master Cylinder:
1.  Must be mounted on upper 2 bolt holes in firewall

Front Wheels:
1.  Wheel offset to the outside will increase header/tire clearance.

Body Mounts:
1.  Collector extensions may touch body mounts.  Some grinding may be required.