#109 Specs  - Stepped tri-Y design
This unique design will give you the ground clearance you need and the performance you desire.

• Power Brakes: OK

• Power Steering: OK (factory)

• Large flywheel = OK

• Starter:  Power Master XS series

• Trans:  Borg Warner 5 spd, Tremec 5 spd.  Can be built to fit powerglide.

• Bellhousing:  Stock 
  If using Lakewood bellhousing it will need to be trimmed for right side header.  Lower control arms may need to be trimmed.

• Frame/Motor mounts:  stock
  Midplate ok in stock location

• Oil filter:  AC PF-25 (stock)

• Oil pan:  Stock type with no kickout 

• Cylinder heads:  Stock or Dart Pro1 is ok

• Ground clearance:  (measured from oil pan rail to bottom of grouping)   
  L-Drop = 8-1/8"                             R-Drop = 8-3/16"

• Customer will need to fabricate custom transmission cross member or purchase a Stahl fabricated cross member

• Installation instructions:
  Right side:  raise front of car at least 2' off the ground.  A lift is recommended for installation.  Remove transmission.  Lift engine with hoist and move to left side of engine bay.  Install right side header from under car.  Do not bolt up yet.  Lower engine into position and bolt to mounts.  Bolt up right side header.
  Left side:  will go in from under car with engine/transmission in position.